Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Pale horse; A TJ pile of parts
View Single Post
Old December 6th, 2009, 02:43 PM   #376
Axle Guru Extraordinaire
Jeepaholic's Avatar
Join Date: 04-08-06
Location: Owosso
Posts: 7,888
iTrader: (120)
Mentioned: 20 Post(s)
Send a message via AIM to Jeepaholic Send a message via MSN to Jeepaholic

Yes but you need 1/16" (16 gauge I think) sheet, 2" wide but you have to be careful to make sure the c is on correctly.

37's should be no problem. 39's if you r easy on the go pedel.

Only down fall is to run stock 60 shafts is an Arb is the only diff you can run.
Jeepaholic is offline   Reply With Quote
Page generated in 0.20630 seconds with 22 queries