Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Pale horse; A TJ pile of parts
View Single Post
Old December 5th, 2009, 08:57 AM   #372
Axle Guru Extraordinaire
Jeepaholic's Avatar
Join Date: 04-08-06
Location: Owosso
Posts: 7,888
iTrader: (120)
Mentioned: 20 Post(s)
Send a message via AIM to Jeepaholic Send a message via MSN to Jeepaholic

That is one of my axle builds, I used a F-250 hp44 as it uses 3" tubes instead of 2 3/4" tube. Used stock ford 60 inner c's and made a sleeve to make up the 1/8" of difference. The outters were so he could run 5 lug, otherwise you can run stock ford outers if you want 8 lug. The short side is a stock ford 60 shaft and the long side is a cut down stock ford unit.
Jeepaholic is offline   Reply With Quote
Page generated in 0.14438 seconds with 22 queries