Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - PB Pollock Sandblasting in Fraser, MI
View Single Post
Old November 5th, 2009, 03:27 PM   #1
amundaza
Terminator 2
 
amundaza's Avatar
 
Join Date: 07-24-07
Location: Rochester Hills, MI
Posts: 1,158
iTrader: (23)
Mentioned: 0 Post(s)
Default PB Pollock Sandblasting in Fraser, MI

Hey guys,

I was originally going to clean up and paint my FSJ axles at home, but it wasn't all that quick. So, I hauled the axles to a sandblasting shop in Fraser, Michigan, that did my CJ5 frame YEARS ago, as well as the 15x8 Jeep wagon wheels for the Guatemalan Grand Wagoneer.

One day and $150 later, I have two sandblasted and primered axles. $55 per axle for blasting and $20 per axle for primer.

I taped off a few critical areas, like the Warn locking hubs and the brake lines and breather vent hoses, so sand wouldn't get inside them. Then just had them blast and primer everything else, since I'll be redoing the front and rear brakes.

Sincerely,
Greg Taylor
Rochester Hills, MI
1989 Grand Wagoneer "Terminator 2"
330" AMC stroker V8








amundaza is offline   Reply With Quote
 
Page generated in 0.06461 seconds with 20 queries