View Single Post
Old October 16th, 2009, 05:06 PM   #11
camccardell
tiger blood
 
camccardell's Avatar
 
Join Date: 10-14-08
Location: Homer MI
Posts: 1,351
iTrader: (20)
Mentioned: 1 Post(s)
Default

that would be awsome man!

I am going to try to machine a plate that will go on the imput side of the transfer case that is also the bracket for bolting it to a crossmember.

I will also add a tube for a bushing, seal, and the input shaft that I want to make out of an outpput shaft off an E40D. I want splines and threads on the other end, so I can add a yoke.

Any junk bw1356 would be good for a mock up
camccardell is offline   Reply With Quote
 
Page generated in 0.03780 seconds with 11 queries