Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1989 f250 slave cylinder removal
View Single Post
Old October 6th, 2009, 10:21 PM   #2
94rangeron35s
bought a Jeep
 
94rangeron35s's Avatar
 
Join Date: 09-06-06
Location: North Muskegon, Michigan..
Posts: 4,451
iTrader: (17)
Mentioned: 0 Post(s)
Send a message via AIM to 94rangeron35s
Default

sounds about right the slave should just unbolt from the housing once off and the new one should bolt back on.. just be careful of the slave lines. going through the side of the bell housing..
94rangeron35s is offline   Reply With Quote
 
Page generated in 0.05373 seconds with 20 queries