Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - My Yj; 6.0 V8, 700R4, D44, D60, H1's, 37's and OBA
View Single Post
Old September 28th, 2009, 11:34 AM   #148
Axle Guru Extraordinaire
Jeepaholic's Avatar
Join Date: 04-08-06
Location: Owosso
Posts: 7,890
iTrader: (120)
Mentioned: 20 Post(s)
Send a message via AIM to Jeepaholic Send a message via MSN to Jeepaholic

Originally Posted by jeepfreak81 View Post
Motor mounts are good

The YJ has been down 2.5 years, and I work 45-65 hours a week in the summer. I just don't have time right now, or the extra cash for that matter especially since my wife is going for her masters now. Do you think I enjoy looking at it sitting there? I'm not going to skip bills to fix a jeep that isn't a DD though.

If you need the axle from under the flatty, I'll pull it into the portable garage and cut the old one out, or you can pick up yours. I just have not had time to do it, and have not really wanted to yet because EVERY swap we have done on either jeep has gone way over budget and time, I have not been driving it anyway because I have not even had time to pull the oil pan and fix it in 2 months.

BTW do you need a jeep 231 case too or just the 231C internals? I know I have some 231C cases. I have not found the jeep ones though as I have not been to my dads.

I know just hairyassing you, same reason mine isn't done.

Na, it would be nice to take it to the swap meet though as some extra $$ would be nice.

Well I would like; the parts for a wide chain and I think the 231c has the better planteary? So guts from a 231c and if you have any J parts my brother needs one

I need to come over and check out the sweet Ford though
Jeepaholic is offline   Reply With Quote
Page generated in 0.15770 seconds with 22 queries