View Single Post
Old September 16th, 2009, 07:02 AM   #43
clarkstoncracker's Avatar
Join Date: 11-03-05
Location: OC - MI
Posts: 42,293
iTrader: (39)
Mentioned: 72 Post(s)
Send a message via AIM to clarkstoncracker

Originally Posted by Mr. Beefy View Post
I got a question... I took mine apart last night and my pin wasn't broke but the ball bearing under the lever was rusted in place. I had to take my pin out then the handle and break the spring and ball bearing out then lube and sand down the bearing. Now that you welded your pin in how do you get the handle out?
I would have to grind out the spot weld.

And if you had grease in there to begin with, you wouldn't have the rust in there
clarkstoncracker is offline   Reply With Quote
Page generated in 0.04238 seconds with 11 queries