View Single Post
Old September 3rd, 2009, 03:32 PM   #7
Senior Member
thrill20's Avatar
Join Date: 07-20-07
Location: Grand Rapids, MI
Posts: 2,161
iTrader: (24)
Mentioned: 0 Post(s)

Are you still running the original rubber lines? Try replacing those. A guy I work with was just going through the same thing. Kept bleading the lines and bench bled the master, then ended up replacing the master cylinder. He got to the point where the only thing left was the soft lines and replaced those and everything worked perfect.
thrill20 is offline   Reply With Quote
Page generated in 0.03002 seconds with 11 queries