Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - help changine rear main oil seal, 351m
View Single Post
Old August 17th, 2009, 12:25 PM   #4
BOGDOG
Senior Member
 
BOGDOG's Avatar
 
Join Date: 11-11-06
Location: White Lake/Wixom
Posts: 2,279
iTrader: (7)
Mentioned: 1 Post(s)
Default

It has been a long time since I did it but IIRC I undid the motor mounts and raised the engine putting some chunks of 2x4 between the motor mounts. Drop the pan then loosen all of the main bearing bolts, remove rear main cap push old half of seal out of block with new seal install other half in main cap retorque all of the bearing cap bolts and put everything back together. Disconnect battery cable as I seem to remember something about engine cranking over when I jacked it up.
BOGDOG is offline   Reply With Quote
 
Page generated in 0.46804 seconds with 20 queries