Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - rig haulin question
View Single Post
Old August 9th, 2009, 08:21 AM   #34
Yota Bill
Senior Member
 
Join Date: 08-24-08
Location: Morrice, Mi
Posts: 3,229
iTrader: (11)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by Broncoholic View Post
No criss cross

45 degree to each corner & compress the susp. Works for my Loaders.

& all the chit I find in Barns. Never lost a load yet, Never use a strap chains & ratchet binders with compressed susp. = Best & safest...2c

loaders dont have a suspension, just a pivot point in the center of the rear axle...trying to fully compress the suspension on anything automotive is difficult at best, if not nearly impossable...much safer to go to the axle, as everyone else in this thread has already stated....for your loaders, continue using the tie down points that are part of the frame, thats what they are for
Yota Bill is offline   Reply With Quote
 
Page generated in 0.04693 seconds with 20 queries