Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Advanceing the timeing 351w
View Single Post
Old August 5th, 2009, 04:35 PM   #4
Daddy Dan
SBF Nut
 
Daddy Dan's Avatar
 
Join Date: 11-18-08
Location: Fowlerville/Michigan
Posts: 890
iTrader: (32)
Mentioned: 0 Post(s)
Default

The spout is located on the driver side fender. Its a little square grey piece that plugs in. You pull that, and set your timing. Try bumping it to 12* instead of the stock 10*. Once your done, you need to plug the spout back in. The computer actually advances these motors quite high. So don't think its holding it back. It will only hold it back if something is not right.
Daddy Dan is offline   Reply With Quote
 
Page generated in 0.04783 seconds with 20 queries