Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - flywheel advice, ford motor/trans in cj7
View Single Post
Old July 27th, 2009, 08:08 PM   #6
brewchief
Senior Member
 
Join Date: 12-01-07
Location: Webberville, MI
Posts: 302
iTrader: (6)
Mentioned: 0 Post(s)
Default

flywheel tooth count needs to match the bellhousing, that truck bell should be the 164 tooth, as long as the balance weight is correct you're good to go, clutch may or may not work, I just used a new napa flywheel and it had two bolt patterns for different size clutches. Not sure on the starter but you may need one, later model trucks went to the small gear reduction type, I am using one in my bronco and like it a lot.
brewchief is offline   Reply With Quote
 
Page generated in 0.05420 seconds with 20 queries