Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - flywheel advice, ford motor/trans in cj7
View Single Post
Old July 27th, 2009, 07:44 PM   #5
rentalrider
Senior Member
 
rentalrider's Avatar
 
Join Date: 11-13-07
Location: West Branch, Mi
Posts: 1,055
iTrader: (3)
Mentioned: 0 Post(s)
Default

Thanks to all. So brewchief, I think you just answered my next question. I've got no problems mounting up a flywheel with different diameter (tooth count) as long as the weight is correct, right? Would I expect to have to change my clutch? (diameter and tooth count same) Or should this mount up, too? I know the pilot bushing will need to be changed as the nose on the two input shafts have a different diameter, but I'm told this should be no biggie? How about starter?

Last edited by rentalrider; July 27th, 2009 at 08:05 PM.
rentalrider is offline   Reply With Quote
 
Page generated in 0.04621 seconds with 20 queries