Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Pale horse; A TJ pile of parts
View Single Post
Old June 14th, 2009, 10:19 AM   #129
Fuck talk, Duck walk!
Skooter_Built's Avatar
Join Date: 11-05-05
Location: Whitelake, MI
Posts: 15,003
iTrader: (28)
Mentioned: 29 Post(s)

Originally Posted by whiterhino View Post
Did you flex it out at all or just check it at ride ht?
Originally Posted by Haggar View Post
Yep, like everyone says, really check the worst cases for clearance. Its a balancaning act of getting them not to hit the frame at droop or the tires at full stuff.
Originally Posted by JeepMann View Post
If you are going to cut the frame its hard to do after the motor mounts because of the funky shape to the frame and the angles it comes out at. I planned on doing that but then decided doing the pie cuts to straighten the front out was going to be a better choice in the long run.
ya, after looking it over i first will start by lowering my coilover hoops down 3" and then will pie cut the frame like you did.

Today im gonna strip down the rear axle, chop the rear frame off, and start mocking up the rear suspension & coilovers.
I'm the man in White.

If you want peace, prepare for war!

Forgiveness is between them and God. It's my job to arrange the meeting.
Skooter_Built is offline   Reply With Quote
Page generated in 0.12397 seconds with 22 queries