Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Pale horse; A TJ pile of parts
View Single Post
Old June 13th, 2009, 08:31 PM   #128
JeepMann
10 Years
 
JeepMann's Avatar
 
Join Date: 11-04-05
Location: Waterford, MI
Posts: 7,082
iTrader: (18)
Mentioned: 0 Post(s)
Send a message via AIM to JeepMann
Default

Quote:
Originally Posted by Skooter_Built View Post
ya, itss gonna be a real tight fit, i did flex it but it hits the high steer tie rod real fast, so i have to modify the front frame section. I always knew this was going to be the trouble but i have seen a few solutions that others have done or i cut off the factory frame right after the motor mounts and build my own.
If you are going to cut the frame its hard to do after the motor mounts because of the funky shape to the frame and the angles it comes out at. I planned on doing that but then decided doing the pie cuts to straighten the front out was going to be a better choice in the long run.
JeepMann is offline   Reply With Quote
 
Page generated in 0.08769 seconds with 20 queries