Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - H1 magnesium wheel inserts for double beadlocks
View Single Post
Old June 12th, 2009, 10:58 AM   #38
Recovering XJ owner
silverxj's Avatar
Join Date: 11-05-05
Location: Michigan
Posts: 5,620
iTrader: (64)
Mentioned: 2 Post(s)

Originally Posted by Tab View Post
I've heard of others having to do it but I got my tsl's to fit so I didn't need to. I would be a bit worried about the new edge (without the metal trim piece) cutting into the bead when clamping down.

I've read that most don't have problems with the TSL's ... why? It doesn't make sense.

I get them to seal sometimes, but I'm tightening the down so hard that it's coning/deforming the outer ring.

I'm going to try and see if there's room to pull the edging off, grind off a tenth or so, put it back on and see if it helps.
silverxj is offline   Reply With Quote
Page generated in 0.14844 seconds with 22 queries