Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1941 MB Slatty/ Project Slat Nasty
View Single Post
Old June 3rd, 2009, 12:16 PM   #18
Axle Guru Extraordinaire
Jeepaholic's Avatar
Join Date: 04-08-06
Location: Owosso
Posts: 7,886
iTrader: (120)
Mentioned: 20 Post(s)
Send a message via AIM to Jeepaholic Send a message via MSN to Jeepaholic

Originally Posted by BeaverTown View Post
Yeah, Jeepaholic, that would be cool if I could check them out. Do you think that I would need to comp cut if i went with either spring? I want to try to avoid that if possible. I measured and I think I can go back about 4-5 inches without having to go full comp, just a little off the back. I have a wedding to attend this weekend, but hopefully I'll be down the following weekend.
Ya they are a lot longer than the stock springs so unless you add to the frame they won't stretch it out that long s to need to comp cut it.
Jeepaholic is offline   Reply With Quote
Page generated in 0.16465 seconds with 22 queries