Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Project: 3/4 ton keepin it low ZJ
View Single Post
Old May 31st, 2009, 05:01 PM   #3
ScottyB's Avatar
Join Date: 05-29-09
Location: Madison, Wi
Posts: 18
iTrader: (0)
Mentioned: 0 Post(s)

A little bumper action that I started today. Still need to cut a passenger side mount and get the nuts welded in and such. Then weld a big plate underneath tying both sides together and doubling as a safety chain mount. And finally weld on some D can never have too many pull points. It's a start and up pretty high so I like that.

Just sitting on there so it's nowhere level or squared up. Still need to do some chassis hacking on the right.

1/4" beef

Eh? Stick welded with 7014. Only have a baby Miller mig, which I wouldn't trust for this.

Last edited by ScottyB; May 31st, 2009 at 05:13 PM.
ScottyB is offline   Reply With Quote
Page generated in 0.22797 seconds with 22 queries