Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Nut and bolt sizes
View Single Post
Old May 19th, 2009, 03:38 PM   #2
Yota Bill
Senior Member
 
Join Date: 08-24-08
Location: Morrice, Mi
Posts: 3,229
iTrader: (11)
Mentioned: 0 Post(s)
Default

get a tap and die set, and then you can use that to fidure out the sizes...also, for the studs anyway, you cna use an open end wrench...find a wrench that the open end fits around the stud with very little slop, then thats the size, but then you'll need a guage to find the TPI or pitch...





besides that, hard to even guess when you didnt say anything about year, make, model, engine size, etc...
Yota Bill is offline   Reply With Quote
 
Page generated in 0.04450 seconds with 20 queries