Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Ford Edelbrock intake, 35X12.50 w/15X10's, hedmen headers, 9" axle
View Single Post
Old May 18th, 2009, 09:23 PM   #18
Lilmuddy
Senior Member
 
Lilmuddy's Avatar
 
Join Date: 11-28-07
Location: Attica, Ohio
Posts: 119
iTrader: (7)
Mentioned: 0 Post(s)
Default

Update . . . headers sold finally!!

OK . . 9" rear axle still laying here and I have the 351M out and ready to sell. 96,000 on it, did run but has sat inside on a stand for the last two years thanks to my last deployment. It currently is complete pan to carb and still has oil in the bottom end and tranny fluid in the cylinders. PLugs are in and exhaust cylinders are sealed with flange cut outs. $100 takes it cause I need the room.
Lilmuddy is offline   Reply With Quote
 
Page generated in 0.06163 seconds with 20 queries