Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - project meh...Home made flat fenders and high line
View Single Post
Old April 1st, 2009, 08:32 PM   #1
Jeep Thrills
Lumbermonkey/pedalpusher
 
Jeep Thrills's Avatar
 
Join Date: 02-14-08
Location: Flushing,Mi
Posts: 716
iTrader: (6)
Mentioned: 0 Post(s)
Default project meh...Home made flat fenders and high line

As in,meh....good enough.I'm in the process of throwing together a second jeep to use up some of the parts I have laying around.78 cj5 frame,older glass body,small block chevy. Amc 20 rear,30 front.The goal is to barter some of my extra parts for the parts I need to finish this,then wheel the hell out of it.

55-71 tub, 78 frame and running gear,dash and heater assembly, 69 windshield, 73 sbc, 82 grille, 80 wagoneer tilt column and bucket seats, wagoneer radiator, TJ gas tank, old-ass Viking winch.

I cut some of the mounting flange off the grill to make the radiator fit.
The rear is an AMC 20 with Moser axles and a Trac Loc that had some busted clips in it, so now it's welded.

I swapped some other stuff and got a bigger bumper for the front, and mounted an old Viking winch.
Attached Thumbnails
Click image for larger version

Name:	102_2102.jpg
Views:	1062
Size:	42.4 KB
ID:	40741   Click image for larger version

Name:	102_2103.jpg
Views:	1029
Size:	43.0 KB
ID:	40742   Click image for larger version

Name:	102_2101.jpg
Views:	1032
Size:	42.0 KB
ID:	40743  

Last edited by Jeep Thrills; April 17th, 2014 at 07:58 AM.
Jeep Thrills is offline   Reply With Quote
 
Page generated in 0.05333 seconds with 21 queries