Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - "Dirthead 509" TJ Project
View Single Post
Old March 28th, 2009, 04:22 PM   #121
Deaner's Avatar
Join Date: 02-09-06
Location: Ortonville, MI
Posts: 7,331
iTrader: (26)
Mentioned: 4 Post(s)
Send a message via AIM to Deaner

Originally Posted by feva4u View Post
Just put the rims on the D60 front. Going to have to grind about 1/16" off one little section of the caliper. I knew it was going to be tight, I'm actually surprised they clear as well as they do

did you get it all the way one ( the wheel ) and it was flush at the back of the hub? Butler is running the same wheels on a HP60, and we had to take the wheels over to ToolMakerPrevo to machine the centers out abit to clear the center of the hub at the base of the studs.

Dirty Minds Jeep Club
Originally Posted by Toolmakerprevo View Post
Well at least I can screw comfortably in a bathtub!
Originally Posted by Nuggets View Post
Half you guys bitchin' about these women are probably dragging home snow cows and tundra pigs from the bar.
Deaner is offline   Reply With Quote
Page generated in 0.06572 seconds with 21 queries