Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - "Dirthead 509" TJ Project
View Single Post
Old March 17th, 2009, 10:36 PM   #108
feva4u
LCG
 
feva4u's Avatar
 
Join Date: 04-01-07
Location: Petoskey, MI
Posts: 10,494
iTrader: (12)
Mentioned: 6 Post(s)
Default

Plates for sure. I'm thinking 3/16" or 1/4" down one side all the way back to the motor mounts on each frame rail. Looking at it, IMO, the best way to do it would be to cut it off on it's way up to the motor mounts and replace from there. I didn't feel that ambitiuos. I was surprised it ended up as straight as is did. The fancy laser level said it was within .1 deg from one side to the other......unfortunately I know I have more angle than that in the concrete so it's...........sort of straight
feva4u is offline   Reply With Quote
 
Page generated in 0.05756 seconds with 20 queries