Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - "Dirthead 509" TJ Project
View Single Post
Old March 8th, 2009, 01:37 PM   #86
Trailrig's Avatar
Join Date: 02-12-06
Location: Flushing, MI
Posts: 2,350
iTrader: (27)
Mentioned: 17 Post(s)
Send a message via AIM to Trailrig

i cut that crossmenber out completely and then put it in the frame, i suggest get it sitting down on the springs first and then decide if you are going to need to chop the frame, only reason i cut mine was because i wanted to keep it low, hindsight i think i would have just ran factory rear Tj springs with relocated buckets

all the way at the bottom
Trailrig is offline   Reply With Quote
Page generated in 0.15989 seconds with 22 queries