Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Ford Edelbrock intake, 35X12.50 w/15X10's, hedmen headers, 9" axle
View Single Post
Old February 24th, 2009, 10:25 PM   #1
Lilmuddy
Senior Member
 
Lilmuddy's Avatar
 
Join Date: 11-28-07
Location: Attica, Ohio
Posts: 118
iTrader: (7)
Mentioned: 0 Post(s)
Default Ford Edelbrock intake, 35X12.50 w/15X10's, hedmen headers, 9" axle

Ok, cleaning out the garage to fund my strait axle and sterling swap. I have the following up for sale and can help deliver with a little gas money.

1. 1979 F150 9" rear axle, complete, drum to drum. Axle had 96,000 original miles on it and I know it need new drums and pads. I will pull the center chunk and take more pics if requested, but the back lash and pinion feels good and it rotates freely. Ratio is 3.5 open axle. I will part this also if someone needs a center chunk, shafts, or housing only. $100 complete OBO


2. 35X12.50 General Tire Grabber MT's mounted on 15X10 Procomp 1079 rims with 3.75 inches of back space. Bolt pattern is 5X5.5" This set also comes with a spare matching rim, like new NO TIRE. Tires are mounted and balanced and ready to go. Tread depth is near new, I had them mounted years ago before two deployments came among and stalled my plans. Two rims have a little rock rash but have no sealing or balancing issues. These will polish up real nice, I already did it once before with great results. $600 firm







3. Hedman Headers, part #89330 fits form 351M/400. These are new never used. 3 bolt flange and the head flange measures 1/4" thick. Rest of the specs can be found on Hedmans website. $125 OBO




4. Edelbrock Aluminum intake Performer 400. Part # 2171,Fits 351m/400. More info. on Edelbrocks web site. Like new codition, cleaned and ready to install. $125 OBO




Stuff like the headers, intake I can ship by UPS at your cost. Axle and tires I can meet mid way, or deliver if needed for gas money. Currently only can accept cash or cashiers check. I am looking for 16X10" 8 lug (8x6.5) aluminum rims or 6" rear lift springs for 1980-1996 ford bronco/F150 that I may consider in trades . Thanks for looking!

Jason
Lilmuddy is offline   Reply With Quote
 
Page generated in 0.08836 seconds with 20 queries