Originally Posted by N8sBroncoMI
napa sold me a combo joint for $13 and i bought a set of u-joing straps. then I took the flange off of my drive shaft and bolted the ujoing right to the 9" yoke. that fit perfectly but I took it all back and bought a crush sleve and swaped my 8.8 yoke onto the 9" and ran the stock drive shaft and flange setup.
My explorer 8.8 yoke/flange is to large for a stock 9" pinion....what 8.8 yoke did you use to be able to put it on a 9"
Or am i just misunderstading your post?
And Part number for said $13 conversion joint.