Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1988 4Runner Clean, Lifted, 35's Needs Work
View Single Post
Old June 2nd, 2006, 02:21 PM   #2
Senior Member
Join Date: 02-03-06
Location: Ferndale, Michigan
Posts: 446
iTrader: (19)
Mentioned: 0 Post(s)

That's a good project, rings and bearings from Toyota would only be a few hundred bucks and a gasket set is cheap aftermarket. There should be no need for more than that. I have done several Toyota motors that way. If it runs now then a machine shop would only mess up Toyota's quality!
robrocketanski is offline   Reply With Quote
Page generated in 0.15133 seconds with 22 queries