Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Are my gears Standard Cut (LP) or Reverse Cut (HP)?
View Single Post
Old February 3rd, 2009, 02:07 AM   #14
Dad Kickin' It OldSkool
Cooter's Avatar
Join Date: 12-04-05
Location: Chi-caw-go
Posts: 4,599
iTrader: (16)
Mentioned: 3 Post(s)


In theory.

But it can get pricey, and you usually spend quite a bit for D60 front end parts. Don't forget that there most likely won't be enough axletube for your long side, either, so you will have to retube at least one side. You also will need axleshafts, and the D60 rear will most likely have a 30 spline carrier.

It can be done, however, but it is usually best to pay next to nothing for the rear D60- they are plentiful enough. It is a decent way to go if you have plenty of time, and want to build the axle up to your own specs, or if you have a line on D60 front parts.
Michigan- The Only Great Lakes State South of the Mason-Dixon Line.
Cooter is offline   Reply With Quote
Page generated in 0.05851 seconds with 21 queries