Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Are my gears Standard Cut (LP) or Reverse Cut (HP)?
View Single Post
Old February 2nd, 2009, 02:26 PM   #10
I am the law.
PavementPounder's Avatar
Join Date: 11-05-05
Location: Birmingham, Michigan 48009
Posts: 29,823
iTrader: (224)
Mentioned: 7 Post(s)

Reverse-cut axle pinions turn the same direction as standard-cut axles in the same position in the vehicle. The pinions turn different directions front-to-rear in order to travel in a particular direction regardless of the axle type because the axles in the vehicle are facing in opposite directions. That guy you quoted is wrong.
PavementPounder is offline   Reply With Quote
Page generated in 0.20090 seconds with 22 queries