Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Are my gears Standard Cut (LP) or Reverse Cut (HP)?
View Single Post
Old February 2nd, 2009, 03:58 AM   #5
dragtruk's Avatar
Join Date: 01-28-09
Location: Portage Mi
Posts: 296
iTrader: (6)
Mentioned: 0 Post(s)
Send a message via AIM to dragtruk

so could i run a low pinion, sandard cut axle in the rear of my jimmy or would i take off in reverse when i put it in drive?
dragtruk is offline   Reply With Quote
Page generated in 0.17122 seconds with 22 queries