View Single Post
Old February 1st, 2009, 09:41 PM   #77
feva4u
LCG
 
feva4u's Avatar
 
Join Date: 04-01-07
Location: Petoskey, MI
Posts: 10,092
iTrader: (11)
Not much done this weekend, got front axle set in place and old bracket welds cleaned off. Found out my 3-link calcs are junk, kept it too narrow. So I designed brackets to go under the frame instead for the lowers and I'll move the axle side lower mounts out wider. Like H a g g a r said, it takes longer to make your own brackets but it saves money.........definitely not time though.



I'll be gone next week on a cruise so it'll be a couple weeks before I can get back to work.
feva4u is offline   Reply With Quote
 
Page generated in 0.03846 seconds with 11 queries