Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Building my sliders
View Single Post
Old June 1st, 2006, 04:04 PM   #6
Senior Member
quicksilver's Avatar
Join Date: 11-05-05
Location: Livonia, MI
Posts: 512
iTrader: (13)
Mentioned: 0 Post(s)

Not really but I could take some. All I did to mount them to the pinch seam was to hold the 3/4"x3/4" angle to the seam and mark were I wanted bolts. Then drill eleven 1/4" holes for eack side with the drill press. Then I clamped the angle to the pinch seam and drilled out the holes using the angle as a guide. Hope that helps.

quicksilver is offline   Reply With Quote
Page generated in 0.11528 seconds with 22 queries