Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 98 TJ Build....Updated 4/16/10
View Single Post
Old January 26th, 2009, 07:16 AM   #300
benny87
Young Gun..!
 
benny87's Avatar
 
Join Date: 08-03-06
Location: Waterford
Posts: 2,933
iTrader: (4)
Mentioned: 2 Post(s)
Default some more updates

Ok, for the updates from this weekend:
-Got the front entirely done. (not fully welded)
-Engine and trans mounts are all in place.
-rear axle tabs are dont for the axle
-Rear hoops are made and ones in place right now







Now heres my issue, when making the back half kit i ended up limiting my full bump because the lower arm hits.(pic 2) So, i messed up and im moving on about it, but i have 3 ways to move on.

1. Raise the entire height of the jeep (changing the front suspension mounts again)
2. Turn the 4link brackets inward and make the distance between the lowers on the axle shorter (might be 4" shorter at make I beleive.)
3. Cut and notch the frame for the lower link with some larger dia. DOM and essentially sleeve the lower link as it passes through the frame.





All the pics are with the suspension at ride height which is 4" if shaft showing on the shock.
benny87 is offline   Reply With Quote
 
Page generated in 0.05398 seconds with 20 queries