Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Building my sliders
View Single Post
Old May 30th, 2006, 10:32 PM   #4
quicksilver
Senior Member
 
quicksilver's Avatar
 
Join Date: 11-05-05
Location: Livonia, MI
Posts: 512
iTrader: (13)
Mentioned: 0 Post(s)
Default

Well thanks to the long weekend I got them done.

So here is my update.

After I built the legs I test fit them and found the front leg didnt sit flat on the umi-fram. I made 2 cuts with my cut off wheel thru 3 sides of the leg about an inch frome the mounting plate. I then beat the snot out of it to close the gaps. After I test fit them again I welded up the slots. I only have a pic of the leg finished. It is the front and rear leg side by side. You can see the angle on the front leg.


I then clamped the legs to the jeep and tack welded the pinch seam mount on. Only pic I have is after it was welded on.


I cut the ends of the main tube at an angle for looks. The only pic I have is of were I marked it to cut.


positioning the main tube for welding.


Then I skiped a few pics and went right for paint...LOL




How the look instaled.



I made them so I could also use them as a step. They do not stick out much from the side.


Im happy with the way they came out. Even the wife said the look good. so Now I might have to build a rear bumper.

Jeremy
quicksilver is offline   Reply With Quote
 
Page generated in 0.07187 seconds with 20 queries