Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - EB44 disk conversion
View Single Post
Old December 5th, 2008, 11:42 AM   #8
halfgassed
Senior Member
 
halfgassed's Avatar
 
Join Date: 06-22-06
Location: da yoop
Posts: 205
iTrader: (7)
Mentioned: 0 Post(s)
Default

you dont even need to put the chevy knuckles on.

If you still have the factory EB d-44 DRUM brake knuckles, the chevy small bearing spindles/backing plates/calipers all bolt onto the factory drum knuckle. You'll have to do a very minimal grinding on the caliper to clear the a small spot on the knuckle (IIRC)

This also allows you to keep the stock EB d-44 tierod.
halfgassed is offline   Reply With Quote
 
Page generated in 0.05642 seconds with 20 queries