Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - EB44 disk conversion
View Single Post
Old December 2nd, 2008, 08:23 PM   #1
88mudder
In the band!
 
Join Date: 03-30-06
Location: waterford michigan
Posts: 3,678
iTrader: (29)
Mentioned: 0 Post(s)
Send a message via AIM to 88mudder Send a message via Skype™ to 88mudder
Default EB44 disk conversion

what do you all recommend for converting a EB44 axle to disk brakes? Will the outers on a fullsize 44 Ford axle bolt right onto the EB axle? Will i have to swap knuckles? New to this and trying to gain as much knowledge about it before i start.

some options ive discovered:

-Chevy Flat tops/high steer arms and TRE's, Chevy disks, chevy outer shaft and Ford Hubs (i still dont know if i want high steer or not, this isnt a decicated wheeler rig)

-Fullsize Ford 44 outers (like said above, will this work without swapping on the fullsize 44 knuckle?)

-Conversion kit ($500 bucks)

Last edited by 88mudder; December 2nd, 2008 at 08:37 PM.
88mudder is offline   Reply With Quote
 
Page generated in 0.04092 seconds with 20 queries