Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Bumper Material
Thread: Bumper Material
View Single Post
Old November 22nd, 2008, 09:47 PM   #6
schanxj
Senior Member
 
Join Date: 12-28-05
Location: Bay City, MI
Posts: 1,135
iTrader: (14)
Mentioned: 0 Post(s)
Default

if its a B2 then plate steel, cold rolled is probably the best choice, unless you're great with a bender dom tubing will look out of place and rectangular tube will be hard to follow the bodyline. plate steel will give you better lines but still be stout. I would say 3/16" thick for the main portion, and 1/4" for the frame mounts. one important fact to remember is the bumper is still only as strong as your weakest link in the setup....your frame...dont forget to use grade 8 hardware
schanxj is offline   Reply With Quote
 
Page generated in 0.04722 seconds with 20 queries