Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 302 carb probs
Thread: 302 carb probs
View Single Post
Old November 20th, 2008, 10:03 PM   #16
DeRanged mudder
completly insane
 
DeRanged mudder's Avatar
 
Join Date: 08-09-07
Location: Hersey, Mich.
Posts: 145
iTrader: (0)
Mentioned: 0 Post(s)
Send a message via Yahoo to DeRanged mudder
Default

You will need to pull the top of the carb off. Once you have the screws out, pull up carefully and slowly. On the edelbrock there are two little plates on top that are sort of tear drop shaped, they have one screw each. Those are the covers for the metering rods. Pull those covers before you pull the carb top. Make sure the pistons aren't seized into place (common problem). If they are, that could be your problem. carefully work them up and down until they move freely. You should be able to push them down with little pressure and they should spring right back up.
DeRanged mudder is offline   Reply With Quote
 
Page generated in 0.05699 seconds with 20 queries