View Single Post
Old November 20th, 2008, 08:57 AM   #4
CheapThrillB2
FAWK YEAH!!
 
CheapThrillB2's Avatar
 
Join Date: 09-06-06
Location: Middleville, MI
Posts: 30,818
iTrader: (61)
Mentioned: 3 Post(s)
Default



this is the spot i was refering to, i smoothed it out with emery cloth and the egg out of roundness to the inner hole only goes about 1/8" or less into the bore. NO damage to the outer surface the bearing presses onto.
CheapThrillB2 is offline  
 
Page generated in 0.03656 seconds with 11 queries