Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - D30 and 8.25 axle shafts
View Single Post
Old May 18th, 2006, 09:45 AM   #1
Yooper In Training
bbaXJ's Avatar
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 6,412
iTrader: (66)
Mentioned: 26 Post(s)
Send a message via AIM to bbaXJ
Default D30 and 8.25 axle shafts

I have a full set of spare shafts I had for my XJ and never needed.

D30 long and short side, inners and outers with good 297/760 joints. Still have unit bearings attached, but those are worn out.....there's some slop, so those aren't worth much except for making it easier to do a trailside swap. $100 obo

29 spline 8.25 shaft for a 97-01 XJ. Will work on either side. Has studs and clean seal surfaces.....ready to go in. $60 obo

Located in Highland, or I work in Auburn Hills and can take them with me there. I'll also be going to Silver Lake over Memorial Day, or Traverse City in the end of June. Prefer not to ship.
bbaXJ is offline  
Page generated in 0.15039 seconds with 22 queries