View Single Post
Old October 6th, 2008, 10:24 AM   #6
chris1044
Senior Member
 
chris1044's Avatar
 
Join Date: 11-05-05
Location: Lost in the mitten!
Posts: 1,997
iTrader: (4)
the easiest way to figure out what you're going to have to trim is to put the truck on jack stands/hoist so the suspension is at full droop...then use a floor jack to push the suspension up (I use a trans jack or stand and lower the hoist)...mark where the tire hits, and trim away.

I don't have any pics on it, though I'm sure you can find them at dezertrangers.com. And more so, it's hard to trim for travel when you're not 100% sure how much travel you'll have and exactly where the wheel will travel since you don't have a kit on the truck...
chris1044 is offline   Reply With Quote
 
Page generated in 0.03184 seconds with 11 queries