View Single Post
Old September 1st, 2008, 08:11 PM   #44
old newb
pfreer's Avatar
Join Date: 07-21-08
Location: Independence KY
Posts: 155
iTrader: (1)
Mentioned: 0 Post(s)

Thats gonna look nice with a 1/2" of liner on it. You should make another hole cover that fits over the shifters with just the shift pattern. Probably you already planned.

You could run some 2" gages in that verticle sheetmetal in front of the shifter.
pfreer is offline   Reply With Quote
Page generated in 0.04507 seconds with 11 queries