Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - My first take at bending tube.
View Single Post
Old August 25th, 2008, 08:59 PM   #1
Rebel2345
NOT GL4x4SucksVideo guy.
 
Rebel2345's Avatar
 
Join Date: 02-01-07
Location: MI
Posts: 3,086
iTrader: (6)
Mentioned: 0 Post(s)
Default My first take at bending tube.

Its not a difficult one, but considering this is the first real tube bumper I've built, I'd say I did pretty good. Almost perfectly symmetrical.


I used the hydraulic bender we have at work (Nelson Hydraulics) and then just a sawzall and 4 inch grinder for the cutting and notching.









I just have to put a couple more braces on it, above is all I could get done in three hours.
Rebel2345 is offline   Reply With Quote
 
Page generated in 0.04701 seconds with 20 queries