Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Where is an engineer when you need one?
View Single Post
Old August 21st, 2008, 08:27 AM   #5
Join Date: 03-27-06
Location: Cedar Rapids, IA
Posts: 35
iTrader: (0)
Mentioned: 0 Post(s)
Send a message via AIM to VTJeepCJ84 Send a message via Skype™ to VTJeepCJ84

For a normal trail cage I would say find someone with a bender you can buy a case of beer for and have them put some bends in for you.

That being said, if done correctly a very fuctional cage can be built with all mitered joints.
Here's and example, I think there are 4 bends total:

Here's the whole thread on that build, it's really long, but the guy does amazing work.
VTJeepCJ84 is offline   Reply With Quote
Page generated in 0.13050 seconds with 22 queries