Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - hacking off a spindle and putting a new one on?
View Single Post
Old May 3rd, 2006, 12:12 PM   #3
KILLER"B"468
Yankabilly
 
KILLER"B"468's Avatar
 
Join Date: 11-06-05
Location: Hendersonville Tn.
Posts: 7,945
iTrader: (19)
Mentioned: 1 Post(s)
Default

If you are going to buy all the stuff to convert. They sell complete axles for $250 at TSC. Yes the spindles are press and weld. But if they are not straight when done. You will wear tires out in no time at all. I had a cracked spindle on mine. Cut and rewelded it up. It works fine, but I have towed a couple hundred miles and I already need a tire. My next step is a new axle.
__________________
being on the eastern edge of the central time zone sucks...it gets dark WAY to early.

Quote:
Originally Posted by jeepbrattt View Post
An occasional jello or vasoline wrestling match isn't out of the question either.
KILLER"B"468 is offline   Reply With Quote
 
Page generated in 0.04846 seconds with 20 queries