Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1" square or 1" round?
View Single Post
Old May 21st, 2008, 05:27 PM   #16
nates4x4
Member
 
nates4x4's Avatar
 
Join Date: 12-29-05
Location: Midland, Mi
Posts: 80
iTrader: (2)
Mentioned: 0 Post(s)
Default

P.S. if you do end up going with pipe or seamed tubing, try to keep the seam in the inside of your bends. We use pipe for several non-structural parts and have great success with it, and it saves money. If you want to "do it right" though, go with D.O.M. tubing, it's very high quality steel.
nates4x4 is offline   Reply With Quote
 
Page generated in 0.05646 seconds with 20 queries