Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - boxing in a frame
View Single Post
Old April 14th, 2006, 09:44 PM   #3
Captain Ledd
Ranger Addiction?
 
Captain Ledd's Avatar
 
Join Date: 11-06-05
Location: Davisburg
Posts: 2,064
iTrader: (31)
Mentioned: 0 Post(s)
Default

Or like me where I have to rip out everything in my channels anyways because it's all rotted, but no welder to close it up *curses

The only bit of advice I have to offer is to do only very short welds and keep switching areas as to not allocate too much heat in one particular spot, it will actually bend stuff out of allignment from heat expandsion. When I took welding even welds about 1" long distorted the piece I was working on if I wasn't careful (I got better towards the end).
Captain Ledd is offline   Reply With Quote
 
Page generated in 0.06239 seconds with 20 queries