Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Strong enough for pulling?
View Single Post
Old May 5th, 2008, 08:08 PM   #7
NOT GL4x4SucksVideo guy.
Rebel2345's Avatar
Join Date: 02-01-07
Location: MI
Posts: 3,117
iTrader: (6)
Mentioned: 0 Post(s)

I did think of the top after I did that little drawing up.

The bottom, I could do, but at the same time, I'm using this bumper to create room for the shackle hanger that will be welded behind the original when I do the Chevy spring swap. There is only about two inches of frame behind the original now.

I could still do it, and just weld the new shackle hanger over the fish plate?

Or I could use one long ass shackle from the stock location like I've seen others do
Rebel2345 is offline   Reply With Quote
Page generated in 0.17394 seconds with 22 queries