Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - WhiteRhino's Latest Mods
View Single Post
Old May 5th, 2008, 12:09 PM   #125
I'm not old, honest...
whiterhino's Avatar
Join Date: 03-07-06
Location: Davisburg MI
Posts: 27,389
iTrader: (24)
Mentioned: 131 Post(s)

Yeah, I see a recent thread on pi rate where he has given some shady advice. Bryce is going to call him in a little bit. I hope he's still as pissed as he was yesterday.:tonka:

Front brakes. Reused the D60 hub, welded up one hole & put in the 5 bolt pattern. Turned down the outer side to fit a standard wheel. Did a combo on the back side. Used a std F150 rotor. Determined a diameter that would work to open the rotor some and turn down the hub. Both were machined. Fit worked well.

Bought a caliper bracket from Blackbird but it wasn't anything standared because he had never done a mod like this. (seemed odd) I had to give him the specific dimensions for the caliper bolt locations. We used a std Chevy 1/2 ton caliper. It all lines up pretty well but could be centered a little better by 1/16-1/8".
whiterhino is offline   Reply With Quote
Page generated in 0.14214 seconds with 22 queries