Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - WhiteRhino's Latest Mods
View Single Post
Old April 21st, 2008, 11:24 PM   #25
Bones
skillicous
 
Bones's Avatar
 
Join Date: 11-06-05
Location: Dearborn Heights, MI
Posts: 11,433
iTrader: (37)
Mentioned: 1 Post(s)
Send a message via AIM to Bones
Default

Quote:
Originally Posted by Tab View Post
Usually the winch is just used to lower the center of gravity to help it climb. It would do nothing for sway. All ass ends will pass the fronts on a wrangler if driven hard on the road too
Looking good guys, when your done you can come over to help me finish mine if you want.
actaully, drawing the suspension down will essentially add a higher psi on the shock, reducing sway. I use the rear winch more for sway control than I do for hill descent...

Quote:
Originally Posted by dodger889 View Post
The enginner on this job failed on thing vertical weld should have plating to give it a little more strenght due to flexing that will cause breakage around the joints of welding. But then what do I know been around the blocks a few time and have seen a few broken frames...
I think you are talking about fish-plating the joints on the frame, but I really have no idea what you are talking about.
__________________
Inviscid Motorsports

Special Thanks and Recommendations to;
Motorcity Machines
Ironman Offroad
Branik Motorsports
Maxxis Tires

Raceline Wheels
PAC Racing Springs
Joint Clutch and Gear
Bones is offline   Reply With Quote
 
Page generated in 0.05590 seconds with 20 queries